This is an old revision of the document!
Wacom Tablets under FreeBSD
These instructions are correct as of FreeBSD 13.
Requirements
- multimedia/webcamd (v3.9.0.5 or newer)
- x11/libwacom
- x11-drivers/xf86-input-wacom
- x11-servers/xorg-server (need HAL support)
Configuration
In /boot/loader.conf, add:
cuse_load="YES"
In /etc/rc.conf, add:
webcamd_enable="YES"
Note: Older FreeBSD versions may have also required:
devd_enable="YES" and hald_enable="YES"
Restart devd, and add your user to the webcamd group:
# service devd restart # pw groupmod webcamd -m <username>
At this point you may need to disconnect and reconnect your tablet.
Force Wacom Device to a specific screen
Some Wacom devices may not function correctly in multiple monitor configurations unless explicitly mapped:
Identify Wacom device port and number with xrandr(1)
xrandr --listactivemonitors
Identify Wacom Device ID the id of your tablet or pen using xinput(1):
xinput
Map Wacom input Device ID to output device:
xinput map-to-output $Device_ID $Output_Device
Repeat the xinput command for each Wacom Device ID found