syncthing [FreeBSD WIKI]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== Setting Up Syncthing =====

[[https://syncthing.net|Syncthing]] is an open-source file synchronization client and server.

===== Installation =====

Install and configure Syncthing to run at boot.

<code>
# pkg install syncthing
# sysrc syncthing_enable=YES
</code>

===== Create Syncthing Shares =====

<code>
# mkdir /var/syncthing/
# chown -R syncthing:syncthing /var/syncthing/
# chmod -R 750 /var/syncthing/
</code>

===== Create configuration backup =====

If this file doesn't already exist, start the ''%%syncthing%%'' service to generate it. Stop the service again after a few seconds.

<code>
# cp /usr/local/etc/syncthing/config.xml{,.orig}
</code>

Update the config file and make the following changes:

<code>
# vim /usr/local/etc/syncthing/config.xml
</code>

  * Change ''%%<folder path="/Sync" ...%%'' to ''%%<folder path="/var/syncthing" ...%%''
  * Change ''%%<defaultFolderPath>%%'' to ''%%/var/syncthing/%%''

===== Add firewall rules =====

Allow incoming traffic on these ports (and then restart your firewall after to load the new rules):

  * TCP 22000
  * UDP 22000
  * (OPTIONAL) TCP 8384 (Syncthing's admin panel, only expose this port if you want to be able to allow remote configuration of this server)

===== Admin GUI with Nginx =====

<code>
server {

  listen 80;

  server_name syncthing.yourdomain.com;

  root /usr/share/nginx/syncthing;
  access_log /var/log/nginx/syncthing.log;
  error_log /var/log/nginx/syncthing.err;

  location / {
    proxy_pass http://127.0.0.1:8384;
  }

}
</code>

===== Start Syncthing and Test =====

<code>
# service syncthing start
</code>

Browse to the Syncthing control panel to start using the tool

<code>
https://[your-servers-ip-address]:8384
</code>

----

{{tag>HowTo}}