Engenius ENH-200
The Engenius ENH-200 is a 2GHz 802.11bgn mesh device suitable for outdoor deployments.
Hardware
- AR7240 SoC
- 2 x 100MBit ethernet ports
- 32MB RAM
- 8MB NOR flash
- 10dBi panel (directional) antenna
The 4 port serial header has an arrow silk-screened above one of the pins (closest to the wifi antenna connectors at the far edge of the board.) Take that as pin 1:
- Pin 1 - 3.3v (normally don't need to connect)
- Pin 2 - GND
- Pin 3 - TX
- Pin 4 - RX
Build instructions
Unimplemented features
The LEDs aren't yet linked into the GPIO setup.
The panel is apparently dual-polarity and can be changed by reprogramming the antenna switch register.
#define ALL0258N_SWITCHCOM_HORIZONTAL 0x09a00210 #define ALL0258N_SWITCHCOM_VERTICAL 0x0a900120
ap91_pci_setup_wmac_switchcom(0, ALL0258N_SWITCHCOM_HORIZONTAL, “horiz”, “horizontal TX, vertical RX”); ap91_pci_setup_wmac_switchcom(1, ALL0258N_SWITCHCOM_VERTICAL, “vert”, “vertical TX, horizontal RX”);